Boulder 860 Manual de instrucciones descargar pdf (Pagina 18)

4-4

BOULDERLINK MESSAGES

Each component in the system can send a message to the

preamplifier which is then shown on its display. This is particularly

helpful in confirming the operating status of each power amplifier in

a multiple amplifier system. Typical messages on an 810 Preamplifier,

1010 Preamplifier or 1012 DAC Preamplifier are as follows.

“AMPLIFIER 1 ERROR” means that an internal power supply has

failed and the amplifier has turned itself off to protect the speakers from

damage.

“AMPLIFIER 1 IS HOT” means that is has turned itself off due to a

higher than normal temperature condition on the heatsinks.

“AMPLIFIER CLIP” means that the amplifier’s output has

momentarily reached its voltage limitation.

“UNIT 1 IS OFFLINE” means that the slave is no longer responding

via Boulderlink. Its Boulderlink cable may have become disconnected, or

the mains power has been disconnected.

“UNIT 1 IS ONLINE” means that the slave is now responding

via Boulderlink in a normal manner and has been recognized by the

master.

BOULDER

LINK

1 2 ... 13 14 15 16 17 18 19 20 21

Sin comentarios

Boulder 860 Manual de instrucciones Pagina 18